Is your washer not spinning, leaking on your floor, or refusing to drain? Our licensed technicians repair every major washing machine brand across Orlando. Most jobs finished on the first visit, same day.
We repair top-load and front-load washers, stackable units and washer-dryer combos from every major brand — with belts, pumps, couplers, lid switches and door boots already on the van.
Book before 2 PM and we aim to be there today.
Certified, background-checked technicians.
Parts and labor, in writing, every time.
Approved before work starts. No surprises.
Most washing machine failures come down to a handful of parts. Here is what we see most often in Central Florida homes, and what it usually means.
The most common call we get. It is usually a worn drive belt, a failed motor coupler, or a lid switch that no longer tells the machine the door is closed. Before you call, redistribute the load: an off-balance drum will stop a modern washer on purpose. If it still won't spin, the part almost always needs replacing, and we carry belts and couplers for the major brands on the van.
Water on the floor usually traces back to one of three places: the door boot seal on front-loaders, a cracked drain hose, or the water inlet valve. Front-load machines in Orlando are especially prone to boot seal mold and tearing because of our humidity. Shut off the water supply behind the machine and call us before the leak reaches your subfloor.
A clogged drain pump filter is the number one cause, and Orlando's hard water makes mineral buildup worse than average. Coins, hairpins and lint block the impeller. If the drum is full of standing water and the pump hums without draining, the pump is likely seized and needs to be serviced.
Check the outlet and the door latch first. If both are fine, the failure is normally the door lock assembly, the main control board, or a tripped thermal fuse. Control board faults are common on machines over eight years old and are one of the repairs where we will tell you honestly whether replacement makes more sense.
Worn suspension rods or shock absorbers on top-loaders, failed drum bearings on front-loaders, or simply an unlevel floor. A washer that walks will eventually damage its own drum and your flooring, so it is worth fixing early.
Odor is almost always mold in the door boot or detergent drawer, a Florida humidity classic. Clothes coming out soaked means the machine is not reaching full spin speed: usually the same belt, coupler or bearing issue behind a no-spin fault.
If your washer stops mid-cycle without spinning, open the door and redistribute the load before anything else. Modern machines halt the spin cycle on purpose when the drum is off-balance, and a heavy towel on one side is enough to trigger it. If it still will not spin with a balanced load, the drive belt, motor coupler or lid switch is the culprit — and that is a technician job.
| Code | Brand | What It Means | Same-Day Fix? |
|---|---|---|---|
| 4C / 4E | Samsung | Water supply error — the machine is not filling. Usually a blocked inlet filter, a kinked hose or a failed inlet valve. | Yes, in most cases |
| SC / 5C | Samsung | Drain error — water is not leaving the drum. Clogged pump filter or failed drain pump. | Yes |
| DC | Samsung | Unbalanced load the machine could not correct. If it repeats with small loads, suspect worn suspension rods. | Yes |
| UB / UE | Samsung / LG | Load imbalance detected during spin. Recurring UB usually means the suspension or the drum bearing. | Usually |
| 3E | Samsung | Motor error — the drive motor or its hall sensor is not reporting correctly. | Depends on part availability |
| LE | LG | Motor locked — often a jammed drum or a failed rotor position sensor. | Usually |
| F7 E1 | Whirlpool / Maytag | Motor speed fault — the drum is not reaching commanded speed. | Usually |
| dL / F5 E3 | Whirlpool | Door lock fault — the machine cannot confirm the door is locked. | Yes |
We repair top-load and front-load washers, stackable units and washer-dryer combos, from every major brand. Our vans carry the parts that fail most often — belts, pumps, couplers, lid switches and door boots — which is why most Orlando washer repairs are finished on the first visit.
Hard water in much of Orange and Seminole County scales up inlet valves and drain pumps faster than the national average, and year-round humidity attacks the rubber door boot on front-load machines. We see those two failures more than any others, so we stock those parts and check for them on every visit — even when you called about something else.
We don't just patch the problem; we identify the root cause to prevent future failures.
A licensed technician tests the machine in your home and identifies the failed component. Typically 30 to 45 minutes.
You get a flat-rate price before any work starts. If you approve the repair, the $79 diagnostic fee is applied to the total. Nothing happens without your OK.
We replace the part with an OEM (Original Equipment Manufacturer) or OEM-equivalent component, run a full test cycle, and leave the machine working. Parts and labor are covered for 30 days in writing.
Installed & Leak-Tested
Bought a new washing machine? We install it properly so it does not become a service call three months later — and we install units purchased anywhere, including secondhand.
A yearly tune-up costs a fraction of a pump replacement, and in this climate it is the difference between a washer that lasts eight years and one that lasts thirteen.
Flat-rate pricing, quoted and approved before any work starts. The diagnostic fee is credited toward the repair.
| Repair | Est. Cost | Time | The Verdict |
|---|---|---|---|
| Drain Pump Replacement | $180 – $340 | 1 – 1.5 hrs | Always Repair |
| Drive Belt Replacement | $130 – $250 | 45 – 60 min | Always Repair |
| Motor Coupler Replacement | $150 – $280 | 1 – 1.5 hrs | Always Repair |
| Door Boot / Gasket (Front-Load) | $250 – $450 | 1.5 – 2 hrs | Repair if < 8 yrs |
| Water Inlet Valve | $160 – $290 | 1 hr | Always Repair |
| Suspension Rods / Shocks | $220 – $400 | 1.5 – 2 hrs | Repair if < 8 yrs |
| Main Control Board | $350 – $600 | 1 – 2 hrs | Consider Age |
| Drum Bearing Replacement | $450 – $800 | 3 – 4 hrs | Usually Replace |
Repair your washer if the fix costs less than 50% of a comparable new machine and the unit is under 8 years old. Replace it if the drum bearing or the main control board has failed on an older machine — those repairs often approach the price of a new washer. Washing machines last 10 to 13 years on average.
Don't see your brand? Call us and we'll tell you.
I really appreciate the professionalism and these guys showed. Thank you again for repairing our refrigerator
Awesome customer support, they fix the dryer in the same day! Work in St. Cloud area
Paid the $80 upfront fee and then when the service tech showed up he found a clogged drain.cleared and then charged us for pump repair. Not good
Great company was very fast and informative!
Couldn't be more pleased with UpFix! The technicians were knowledgeable, professional & very pleasant. They came within the time frame given and worked fast & efficient. Would definitely call them for future needs if any. Thanks!
Dryer Repair in Orlando
I had a great experience with UpFix Appliance Repair for a washing machine repair. From start to finish, the entire process was smooth and professional. Scheduling the appointment was incredibly easy, and I appreciated the clear communication and follow-up updates throughout the service process. The technician was outstanding — very knowledgeable, respectful, and detail-oriented. You could really tell he took pride in his work and cared about doing the job right. He carefully diagnosed the issue, explained everything clearly, and made sure the repair was completed thoroughly and cleanly. It’s not always easy to find reliable service companies, but UpFix definitely exceeded my expectations. I would absolutely recommend them to anyone needing appliance repair services.
I would like to acknowledge that Dalberto was an excellent technician. He performed the service with great professionalism, competence, and attention to detail. He was very kind throughout the entire visit, explained what he was doing, and completed the work with excellence. We are very satisfied with the service he provided and truly appreciate his dedication and outstanding work.
We serve Orlando and a 35-mile radius of Central Florida — usually the same day.
Most Orlando washer repairs are finished the same day. Book before 2 PM and we will be there today.
